What is the average cost of repairing a well pump?
National 2026 cost guides put most well pump repairs between $375 and $1,600. Small parts cost less: a pressure switch runs about $120 to $200 and a start capacitor about $100 to $150. A full pump replacement runs about $1,500 to $4,000 installed. Well depth is the biggest factor.
How long does a well pump last?
Many well pumps give a decade or more of service. Once a pump passes 10 to 12 years old, most well pros suggest replacing it instead of paying for a big repair. A failing pressure tank, sediment in the well and running the pump dry all wear it out sooner.
How can I tell if my well pump is going bad?
Watch for low or uneven pressure, sputtering faucets, a pump that clicks on and off often, a jump in your power bill, or sand and air in the water. If you have no water at all, power is on and the pressure switch works, the pump has likely failed.
Does a plumber fix a well pump?
Some plumbers handle above-ground parts like pressure switches and tanks. A deep submersible pump is different. It takes a pump hoist to pull, and Oklahoma licenses pump installers through the Oklahoma Water Resources Board. A well specialist is usually the faster fix.
How long does it take to fix a broken well pump?
Above-ground fixes like a pressure switch or capacitor are often done in one short visit. Pulling and replacing a submersible pump takes longer, depending on depth and the condition of the pipe and wire. We'll give you a time estimate once we know what failed.
What is the average cost of drilling a new water well in Oklahoma?
A complete Oklahoma well system (casing, pump, tank, wiring and permits) runs about $8,950 to $13,450 at 150 feet and $10,600 to $16,600 at 200 feet, per WellDrillingCosts' 2026 estimates. The average Oklahoma well is about 185 feet deep. Drilling alone runs about $25 to $55 per foot. Your land's depth to water matters most.
How deep is the average water well in Oklahoma?
The average Oklahoma well is about 185 feet deep, per welldrillingcosts.com. Yours could be shallower or deeper. The Oklahoma Water Resources Board keeps well records that show how deep nearby wells were drilled.
Can I drill my own water well in Oklahoma?
Not legally in most cases. WellDrillingCosts says Oklahoma has no homeowner self-drilling exemption, and DrillerDB says state law requires a licensed water well driller for all drilling work. Every well also has to meet state construction standards and be reported to the OWRB.